This document describes the
following Point System topics:
Focal Point - CETTF100
10Mbps Ethernet TX-FL Media Converter
CETTF100 SNMP MIB Variables
The following manageable
features are available for the CETTF100:
- BiaIndex -
(Integer, read only) "Burned In Address." This is the serial number of the
cabinet into which this CETTF100 is installed.
- SlotIndex -
(Integer, read only) The cabinet slot into which this CETTF100 is
installed.
- Groups -
(String, read/write) This is the Device Group String for this CETTF100. For
more information on Device Group Strings, see the help for Configuration Management.
- MRevision -
(String, read only) This is the marketing revision level of the device. It is
the last three digits of the part number.
- CfgMatch -
(Integer, read only) This value indicates whether or not this particular
CETTF100 is selected to receive configuration changes. For more information,
see the help for Configuration Management.
- SerialNumber -
(Integer, read only) The serial number for this CETTF100
- ConnA, ConnB -
(Integer, read only) The styles of the connectors installed in this device
during manufacturing. ConnA is the Fiber interface, and ConnB is the Copper
interface
- TPLink,
FiberLink - (Integer, read only) The Ethernet link state for each of the
two media connectors.
- Fault -
(Integer, read only) The value of this variable is yes(1) when either TPLink
or FiberLink has the value linkDown(2).
- TPActivity,
FiberActivity - (Integer, read only) Network traffic activity indicators
for the two interfaces.
- AutoCross -
(Integer, read/write) Enable/Disable control for automatic Ethernet TX/RX
pair correction.
- LinkPassThrough
- (Integer, read/write) Enable/Disable control for the Link Alert feature.
When Link Alert is enabled, a loss of link on one interface causes the
CETTF100 to drop link on the opposite interface so that the attached
equipment can detect the fault.
- ConfigMode -
(Integer, read only) The CETTF100 has a hardware switch block that can be
used to set AutoCross and LinkPassThrough, and disallow software changes to
these values. The ConfigMode variable shows the state of the switch - i.e. it
indicates whether or not Software changes are locked out.
- Enabled -
(Integer, read/write) Traffic through this CETTF100 can be disabled via this
control.
|
|
